2014 in the original polystyrene board on the basis of the market, Ming Da thermosetting materials developed Class A HIP-modified polystyrene board, has taken the lead through the A-level detection fire in Jilin. 1324-4400655 company focused on the future, to develop technology products, investment in equipment, technology transfer and other areas of cooperation allow. Eps modified polystyrene board, gold plate, A-class fire insulation board, wall insulation materials, insulation panels parasol, eps foam board insulation board fire FAE cellular isolation is a typical class A polystyrene board, both traditional Organic small density polystyrene board insulation resistance, low temperature resistance, there is a certain degree of flexibility, low water absorption, good impact resistance and other excellent physical properties, and properties of inorganic materials with fire-resistant, fire does not melt upon contact with Notations , high strength, widely used in building exterior insulation systems. Light weight, compressive strength, high tensile strength, low water absorption, long service life. Installation is simple, safe structure, greatly reducing construction costs. Class A fire retardant properties. Thermal conductivity, ranged between 0.033-0.038, good insulation properties, energy saving and environmental protection. Achieve a balanced Uniform Building insulation materials insulation properties, physical properties, fire performance of the three. External wall insulation systems have been widely used, but the introduction of national high-rise building fire safety standards, it becomes very bleak outlook, the fire performance of traditional eps foam board is difficult to achieve a Class A fire-retardant effect. All along, polystyrene plates are considered to be most suitable for use as wall insulation materials, relying on its superior product performance, when people are worried about the future of polystyrene board, A grade polystyrene board appeared to break the deadlock , is bound to set off a big storm in the future external wall insulation industry. Class A thermosetting coating-modified polystyrene board introduction of imported raw materials, fire retardant materials all imported from abroad, the "particle fire barrier film" technology, the use of EPS monomer copolymerization make the particles have the same physical characteristics and Fire and the use of micro-phase composite technology fireproof insulating film is formed on the surface of each of the organic particles, so that each particle of organic particles formed relatively fire units. Which, in case of fire insulation barrier forming a continuous honeycomb structure, flame propagation and penetration barrier, to prevent burning occurs. Class A thermosetting coating-modified polystyrene board while maintaining excellent physical properties of polystyrene board on the original, so that improved from thermoplastic polystyrene board thermosetting, effectively improve the fire performance of polystyrene board, you can reach level A2 , through modified so that the thermal conductivity of polystyrene board, compression performance indicators strength, water absorption, dimensional stability has been greatly improved. Polystyrene particles are formed around the fire performance of special inorganic filler material body, material uniformity, isolated from the air, which completely changed the polystyrene board a fire contraction droplet defects. Enhance the physical properties of the polystyrene plates. The A-level infiltration thermosetting modified polystyrene board is the traditional EPS polystyrene board or graphite infiltrated polystyrene board, after curing polymerization is one of the new products. In this exhibition, Changchun City, Ming-Tat machinery and equipment manufacturing is a typical representative of this aspect of the material.